![]() |
Note: This document is also available in other formats |
---|---|
A PDF version of this document along with all current and older documentation in PDF format can be found at https://my.clavister.com. It is also available as a single HTML page. |
![]() |
Important: Only cOS Core version 11.00.00 or later is supported |
---|---|
The W50 hardware product can run any cOS Core version from 11.00.00 onwards. Earlier versions are not supported and a downgrade should not be attempted. |
This section details the unpacking of a single NetWall W50 device. Open the packaging box used for shipping and carefully unpack the contents. The packaging should contain the following:
The NetWall W50 appliance.
RJ45 console cable.
Power cable.
Rack mount kit consisting of:
2 x brackets with screws suitable for a 19-inch rack.
2 x ball-bearing slide-rails with screws.
Note that the NetWall W50 comes with only a single power supply unit (PSU) installed as standard. This can be for AC (the default) or DC power. A second PSU for redundancy can be ordered separately from a Clavister sales office and fitted on-site into the unused PSU slot on the back of the unit. This topic is discussed further in Section 5.1, PSU Replacement.
![]() |
Note: Report any items that are missing |
---|---|
If any items are missing from the NetWall W50 packaging, please contact your sales office. |
Support Agreements
All purchasers of a new NetWall hardware product must also subscribe to one of the available cOS Core support agreements. These provide access to cOS Core updates and provide a hardware replacement service in the event of a hardware fault. The terms of warranty are described in Chapter 8, Warranty Service, along with a description of the hardware replacement procedure.The Cold Standby Service
To ensure maximum uptime, a Cold Standby (CSB) Service is available from Clavister as an addition to certain cOS Core support agreements. This service allows a second, identical NetWall W50 unit to be purchased at a discount so that it can quickly substitute for the original unit in case of failure, with the ability to quickly reassign the original cOS Core license to the standby unit. When the faulty unit is returned to Clavister, a new cold standby unit is immediately sent back. More details about the CSB service can be found in the separate NetWall Hardware Replacement Guide publication.Downloading NetWall W50 Resources
All documentation, version upgrades and other resources for the NetWall W50 can be downloaded from the Clavister website after logging into the relevant MyClavister account.Contacting Clavister Product Support
Clavister customer support can be contacted by logging into https://my.clavister.com and reporting an issue online. Alternatively, the direct support telephone number is +46 (0)660-29 77 55 (answered 24/7). Sales enquiries should be directed to the head office number +46 (0)660-29 92 00 or a local sales office during the relevant business hours.End of Life Disposal
The NetWall W50 appliance is marked with the European Waste Electrical and Electronic Equipment (WEEE) directive symbol which is shown below.
The product, and any of its parts, should not be discarded using a regular refuse disposal method. At end-of-life, the product and parts should be given to an appropriate service that deals with the disposal of such specialist materials.
![]() |
WARNING: REPLACE INTERNAL BATTERIES CORRECTLY |
---|---|
THERE IS A RISK OF EXPLOSION IF AN INTERNAL BATTERY IS REPLACED WITH THE INCORRECT TYPE. DISPOSE OF ANY USED INTERNAL BATTERIES APPROPRIATELY. |