These log messages refer to the SYSTEM category.
2.49.1. [ID: 641] A new kernel exception report was generated
- Log Categories
- SYSTEM
- Log Message
- A new kernel exception report was generated.
- Default Log Severity
- Emergency
- Parameters
- file
- Explanation
- The system encountered a serious error. A report describing the exception has been generated and saved.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Contact customer support and provide the exception report.
2.49.2. [ID: 235] Out of memory initializing data plane[...]
- Log Categories
- SYSTEM
- Log Message
- Out of memory initializing data plane processing units.
- Default Log Severity
- Emergency
- Parameters
-
- Explanation
- A memory allocation attempt failed when allocating memory for a critical subsystem within data plane. Normal operation cannot
be guaranteed.
- Gateway Action
- Abort
- Action Description
- None
- Proposed Action
- Investigate why the system is low on RAM. Review the configuration and try to free more RAM.
2.49.3. [ID: 583] All systems shutdown
- Log Categories
- SYSTEM,CONFIG
- Log Message
- All systems shutdown.
- Default Log Severity
- Notice
- Parameters
- reason
- Explanation
- Shutdown of all virtual systems.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.4. [ID: 313] Aborted shutdown of all systems
- Log Categories
- SYSTEM,CONFIG
- Log Message
- Aborted shutdown of all systems.
- Default Log Severity
- Notice
- Parameters
- reason
- Explanation
- Shutdown of all virtual system has been aborted.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.5. [ID: 231] All systems shutdown notice
- Log Categories
- SYSTEM,CONFIG
- Log Message
- All systems shutdown notice.
- Default Log Severity
- Notice
- Parameters
- time, reason
- Explanation
- Shutdown of all virtual systems will begin at the specified time.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.6. [ID: 392] Failed to create backup file
- Log Categories
- SYSTEM
- Log Message
- Failed to create backup file.
- Default Log Severity
- Alert
- Parameters
- file, reason
- Explanation
- Attempt to create a backup failed.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Make sure there is enough memory on the disk.
2.49.7. [ID: 193] Backup file created
- Log Categories
- SYSTEM
- Log Message
- Backup file created.
- Default Log Severity
- Notice
- Parameters
- file
- Explanation
- A backup file was created.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.8. [ID: 1073] Leaving Daylight Saving Time
- Log Categories
- SYSTEM
- Log Message
- Leaving Daylight Saving Time.
- Default Log Severity
- Information
- Parameters
-
- Explanation
- Daylight Saving Time change, DST is not in use.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.9. [ID: 1074] Entering Daylight Saving Time
- Log Categories
- SYSTEM
- Log Message
- Entering Daylight Saving Time.
- Default Log Severity
- Information
- Parameters
-
- Explanation
- Daylight Saving Time change, DST is in use.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.10. [ID: 390] Exception report generated
- Log Categories
- SYSTEM
- Log Message
- Exception report generated.
- Default Log Severity
- Emergency
- Parameters
- file
- Explanation
- The system ended up in an unrecoverable erroneous state and had to be restarted. A report describing the exception has been
generated and saved.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Contact customer support and provide the exception report.
2.49.11. [ID: 1072] System time set
- Log Categories
- SYSTEM
- Log Message
- System time set.
- Default Log Severity
- Information
- Parameters
-
- Explanation
- New system time was set with CLI time command (admin).
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.12. [ID: 404] PKG file was successfully applied
- Log Categories
- SYSTEM
- Log Message
- PKG file was successfully applied.
- Default Log Severity
- Notice
- Parameters
- file
- Explanation
- PKG file was successfully applied.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.13. [ID: 244] Failed to apply PKG file
- Log Categories
- SYSTEM
- Log Message
- Failed to apply PKG file.
- Default Log Severity
- Alert
- Parameters
- file, reason
- Explanation
- PKG file could no be applied.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Verify that the file is compatible with the system.
2.49.14. [ID: 190] Failed to validate PKG file
- Log Categories
- SYSTEM
- Log Message
- Failed to validate PKG file.
- Default Log Severity
- Warning
- Parameters
- file, reason
- Explanation
- PKG file was not considered valid.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Verify that file is compatible with the system.
2.49.15. [ID: 786] Process exited with non-zero status code
- Log Categories
- SYSTEM
- Log Message
- Process exited with non-zero status code.
- Default Log Severity
- Error
- Parameters
- module, code, reason
- Explanation
- A process exited unexpectedly with a status code that indicates that an error occurred.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.16. [ID: 785] Process exited because of signal
- Log Categories
- SYSTEM
- Log Message
- Process exited because of signal.
- Default Log Severity
- Error
- Parameters
- module, code
- Explanation
- A process exited unexpectedly due to a signal, which indicates that an error occurred.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.17. [ID: 794] Generating crashdump report
- Log Categories
- SYSTEM
- Log Message
- Generating crashdump report.
- Default Log Severity
- Error
- Parameters
- module
- Explanation
- Process malfunctioned, and a crashdump report is being generated.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Earlier log messages may give additional information about the reason of the malfunction.
2.49.18. [ID: 800] Killing process that did not exit in time
- Log Categories
- SYSTEM
- Log Message
- Killing process that did not exit in time.
- Default Log Severity
- Error
- Parameters
- module, code
- Explanation
- Process was instructed to shut down and exit, but failed to do so in time. Terminating it with a signal, specified by the
code parameter.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.19. [ID: 798] Process is not responding
- Log Categories
- SYSTEM
- Log Message
- Process is not responding.
- Default Log Severity
- Warning
- Parameters
- module, count
- Explanation
- The process is not responding, the count parameter specifies the number of times the process has failed to respond.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.20. [ID: 799] Removing unresponsive process
- Log Categories
- SYSTEM
- Log Message
- Removing unresponsive process. Sending signal.
- Default Log Severity
- Error
- Parameters
- module, code
- Explanation
- Process was unresponsive and it will be terminated by sending a signal. The code parameter specifies the signal number.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.21. [ID: 797] Restarting process
- Log Categories
- SYSTEM
- Log Message
- Restarting process.
- Default Log Severity
- Notice
- Parameters
- module
- Explanation
- Process was restarted.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Look for prior log messages to find the reason for why the process was restarted.
2.49.22. [ID: 796] Process did not exit in time
- Log Categories
- SYSTEM
- Log Message
- Process did not exit in time. Sending signal.
- Default Log Severity
- Error
- Parameters
- module, code
- Explanation
- Process was instructed to shut down and exit, but failed to do so in time. Terminating it with a signal, specified by the
code parameter.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.23. [ID: 1058] Process exited unexpectedly
- Log Categories
- SYSTEM
- Log Message
- Process exited unexpectedly.
- Default Log Severity
- Error
- Parameters
- module, code
- Explanation
- A process exited unexpectedly.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.24. [ID: 990] Configuration has been reset to factory[...]
- Log Categories
- SYSTEM
- Log Message
- Configuration has been reset to factory default.
- Default Log Severity
- Notice
- Parameters
-
- Explanation
- Configuration has been reset to factory default.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.25. [ID: 991] System has been reset to factory default
- Log Categories
- SYSTEM
- Log Message
- System has been reset to factory default.
- Default Log Severity
- Notice
- Parameters
-
- Explanation
- System has been reset to factory default.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.26. [ID: 459] Revert has been applied
- Log Categories
- SYSTEM
- Log Message
- Revert has been applied.
- Default Log Severity
- Notice
- Parameters
-
- Explanation
- System has been reverted to state prior latest perform config/system restore.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.27. [ID: 558] Failed to revert
- Log Categories
- SYSTEM
- Log Message
- Failed to revert.
- Default Log Severity
- Emergency
- Parameters
- reason
- Explanation
- System could not be reverted to Last Known Good.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Uploading and apply a backup file. If not resolved perform a reset to factory default.
2.49.28. [ID: 361] System shutting down
- Log Categories
- SYSTEM,CONFIG
- Log Message
- System shutting down.
- Default Log Severity
- Notice
- SNMP Trap Category
- SHUTDOWN
- SNMP Trap MIB name
- ssmShutdown
- SNMP Trap MIB OID
- 1.3.6.1.4.1.5089.3.0.2020.0.1005 (STREAM-TRAPS-MIB)
- Parameters
- reason
- Explanation
- System shutting down.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.29. [ID: 1023] Preparing to shut down
- Log Categories
- SYSTEM,CONFIG
- Log Message
- Preparing to shut down.
- Default Log Severity
- Notice
- Parameters
-
- Explanation
- The system is preparing to shutdown and will take down connections to other hosts. E.g. IKE/IPsec SAs.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.30. [ID: 427] System started
- Log Categories
- SYSTEM,CONFIG
- Log Message
- System started.
- Default Log Severity
- Notice
- SNMP Trap Category
- STARTUP
- SNMP Trap MIB name
- coldStart
- SNMP Trap MIB OID
- 1.3.6.1.6.3.1.1.5.1 (SNMPv2-MIB, RFC3418)
- Parameters
- name, version
- Explanation
- The system has started and loaded the configuration.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.31. [ID: 1002] System could not be rebooted using the[...]
- Log Categories
- SYSTEM
- Log Message
- System could not be rebooted using the content of upgrade package and has been reverted.
- Default Log Severity
- Emergency
- Parameters
- reason
- Explanation
- System could not be rebooted using the content of upgrade package and has been reverted.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Verify that the upgrade package is intact.
2.49.32. [ID: 992] System could not be reconfigured using the[...]
- Log Categories
- SYSTEM
- Log Message
- System could not be reconfigured using the content of upgrade package and will be reverted.
- Default Log Severity
- Emergency
- Parameters
-
- Explanation
- System could not be reconfigured using the content of upgrade package and will be reverted.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Verify that the upgrade package is intact.
2.49.33. [ID: 1003] System was successfully upgraded
- Log Categories
- SYSTEM
- Log Message
- System was successfully upgraded.
- Default Log Severity
- Notice
- Parameters
-
- Explanation
- System has been upgraded using the upgrade package.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.49.34. [ID: 382] Out of memory setting up virtual system
- Log Categories
- SYSTEM
- Log Message
- Out of memory setting up virtual system.
- Default Log Severity
- Emergency
- Parameters
-
- Explanation
- A memory allocation attempt failed when allocating memory needed to initialize a virtual system. The virtual system failed
to initialize.
- Gateway Action
- Abort
- Action Description
- None
- Proposed Action
- Investigate why the system is low on RAM. Review the configuration and try to free more RAM.
2.49.35. [ID: 290] Module was restarted
- Log Categories
- SYSTEM
- Log Message
- Module was restarted.
- Default Log Severity
- Critical
- Parameters
- module
- Explanation
- The monitored module was restarted by the system.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Check that the module have been restarted and examine the cause of the restart.
2.49.36. [ID: 318] Failed to start module
- Log Categories
- SYSTEM
- Log Message
- Failed to start module. Restarting system.
- Default Log Severity
- Critical
- Parameters
- module
- Explanation
- A monitored module could not be started which lead to a restart of the complete system.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Examine why the module could not be started and, in case of a re-start attempt, the cause of the initial failure.
cOS Stream 4.00.03 Log Reference Guide
