These log messages refer to the MANAGEMENT category.
2.30.1. [ID: 1676] Centralized management control re-enabled
- Log Categories
- MANAGEMENT
- Log Message
- Centralized management control re-enabled.
- Default Log Severity
- Warning
- Parameters
-
- Explanation
- A logged in user rejected local configuration changes that were disabling centralized management control. The System is now
again under centralized management control.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Audit the system for changes and if needed re-export configuration from the centralized management system.
2.30.2. [ID: 1672] Centralized management control being disabled[...]
- Log Categories
- MANAGEMENT
- Log Message
- Centralized management control being disabled by user request.
- Default Log Severity
- Warning
- Parameters
-
- Explanation
- A user logged in via console issued the "localconfiguration -enable" command. Issuing this command will remove the node from
centralized management system, allowing for local configuration changes to be performed and not tracked by centralized management.
This may be a security breach.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- Verify eventual configuration changes, determine if they are correct. The original state and configuration can be reset by
exporting the configuration from the centralized management system.
2.30.3. [ID: 1001] Centralized management control has been[...]
- Log Categories
- MANAGEMENT
- Log Message
- Centralized management control has been disabled.
- Default Log Severity
- Information
- Parameters
-
- Explanation
- Centralized management control has been disabled and user management has been enabled.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- None
2.30.4. [ID: 1000] Centralized management control has been[...]
- Log Categories
- MANAGEMENT
- Log Message
- Centralized management control has been enabled.
- Default Log Severity
- Information
- Parameters
-
- Explanation
- Centralized management control has been enabled and user management has been disabled.
- Gateway Action
- None
- Action Description
- None
- Proposed Action
- In order enable user management, use the CLI command usermanagement.