Properties

LocalUndelivered

How to treat (allowed) packets to the firewall that do not match open ports (netcon, snmp, etc). (Default: DropLog)

PipeDupLog

Whether to log when a pipe object is used more than once by the same flow. (Default: LogAlways)

TTL0OnFwd

What action to take when TTL is reaching zero while being forwarded by the firewall (only possible if IPSettings:TTLMin=1). (Default: DropLog)

NotLocalEnetDest

When a unicast Ethernet packet is received, whose destination is not that of the receiving interface, the packet will be dropped (unless the firewall is running in transparent mode). This is normal. This setting will allow you to log such an event. Note that the log will have priority 'debug'; make sure that the log receiver is set to receive 'debug' priority logs if this is what you want. (Default: Drop)

MaxRebootDelay

The maximum number of seconds that a reboot request can be delayed in order to complete critical tasks such as writing down crash reports. (Default: 0)

AppRestartOnError

Restart application on critical application error. (Default: Yes)

PacketOrderPreservation

Controls the system's efforts to preserve packet order as packets are processed and forwarded. The performance will be reduced when stricter packet ordering is requested. Changes to this setting will not be applied until the system is restarted. (Restart-required; Default: Performance)

HugePages

Specifies the type of huge pages to use when pre-allocating dataplane memory. Using 1 GB memory pages may improve performance. (Restart-required; Default: Auto)

HugePageMapping

Specifies the type of memory mapping to use for dataplane. This should only be changed to resolve memory-related bootup-problems, as changing this may cause such problems. (Restart-required; Default: Legacy)

QuickShutdown

Perform quick shutdown by only performing the bare essential cleanup tasks. (Default: No)

ExtendedConfigDebugging

Extended debug messages during system configuration. Should only be enabled in collaboration with the support department. (Default: No)

FlowUsageEnabled

Controls if flow usage, that tracks packets and bytes forwarded on each flow, is enabled. (Default: Yes)

ReportKubeEvents

Report certain types of events to Kubernetes. (Default: Yes)

MonitorKernelMessages

Process kernel messages and record them in the diagnose console. (Default: Auto)