Properties

UDPSrcPort0

How to treat UDP packets with source port 0. (Default: DropLog)

Port0

How to treat TCP/UDP packets with destination port 0 and TCP packets with source port 0. (Default: DropLog)

WatchdogTimerTime

Number of non-responsive seconds before watchdog is triggered (0=disable). (Default: 180)

BufFloodRebootTime

How long to allow completely flooded buffers before rebooting the firewall. (Default: 3600)

ScrSave

Screen saver selection. (Default: ScrSaveBlank)

StatusBar

Status bar control. (Default: Auto)

ScrSaveTime

Idle seconds before screen saver is automatically activated (0=disable). (Default: 300)

HighBuffers_Dynamic

Allocate the HighBuffers value dynamically. (Default: Yes)

HighBuffers

Number of packet buffers to allocate in addition to the ~200 initial buffers. (Default: 1024)

LocalUndelivered

How to treat (allowed) packets to the firewall that do not match open ports (snmp, scp, netcon, etc). (Default: DropLog)

MaxPipeUsers

Max number of concurrently tracked pipe users. (Default: 1024)

Reassembly_MaxConnections

Maximum percentage of the maximum allowed connections that data reassembly may be performed on. (Default: 80)

Reassembly_MaxProcessingMem

Maximum percentage of device memory that may be used for processing data on reassembled connections. (Default: 3)

WCFPerfLog

Enables periodical logging of Web Contentent Filtering resolving performance. (Default: Disabled)

AllowIPRules

Allow using IPRules in addition to IPPolicies. (Default: Yes)

EnablePollOffload

Enable interface poll offloading. (Default: Yes)

AllowNonCompatibleIfaces

Allow attaching possibly non-compatible/untested Ethernet interfaces. (Default: No)

InterfaceInterruptMode

Specifies whether interface packet reception should use interrupts instead of polling. Interrupt mode sacrifices performance in order to lower the CPU load. This only works on a subset of interfaces and also depending virtualization software. Check the manual for more information. Requires system restart to take effect. (Default: Auto)

AVSigLimit

Limit the number of signatures to use. (Default: 100%)

EnforceStrongPasswords

When enabled, newly created or modified user passwords must comply to predefined complexity rules. Passwords created before enabling this setting will NOT be verified. (Default: Yes)

HTTPPipeliningMaxReq

Maximum number of pipelined requests in HTTP. (Default: 64)

DeviceIntelligence

Device Intelligence makes it possible to identify neighbor devices that are communicating through this firewall. (Default: No)