Properties

Name

Specifies a symbolic name for the interface. (Identifier)

IP

The IP address of the L2TPv3 client interface.

LocalNetwork

The network on local side of the L2TPv3 tunnel.

PseudowireType

Specifies if L2TPv3 should tunnel Ethernet or IEEE 802.1Q (VLAN) tagged Ethernet frames. (Default: Ethernet)

Protocol

Specifies if L2TPv3 should tunnel over IP (115) or UDP. (Default: UDP)

RemoteEndpoint

The IP address of the L2TPv3 server.

OriginatorIPType

Specifies what IP address to use as source IP in e.g. NAT. (Default: LocalInterface)

OriginatorIP

Manually specified originator IP address to use as source IP in e.g. NAT.

IPsecInterface

Use this IPsec interface to encypt the traffic to the L2TPv3 server. (L2TP/IPsec). (Optional)

AutoRouteMetric

Specifies the metric for the auto-created route used by the L2TPv3 Client. (Default: 100)

HostName

The host name for this L2TPv3 Client. (Used in the Host Name AVP). (Optional)

RouterID

Router ID. (Used in the Router ID AVP). (Optional)

DHCPPassthrough

Allow DHCP to pass through transparently. (Default: No)

NonIPPassthrough

Allow non-IP protocols to pass through transparently. (Default: No)

SNMPIndex

Interface index assigned by the system when persistent interface indexes are enabled. (Default: 0)

Attribute

Special Attribute of the current object. (Optional)

MemberOfRoutingTable

All or Specific. (Default: All)

RoutingTable

Specifies the PBR table to insert the interface IP route into. It also means that the specified routing table will be used for all routing lookups, unless overridden by a PBR rule. (Default: main)

ProxyARPAllInterfaces

Always select all interfaces, including new ones, for publishing routes via Proxy ARP. (Default: No)

ProxyARPInterfaces

Specifies the interfaces on which the firewall should publish routes via Proxy ARP. (Optional)

Zone

(Optional) Specifies the Zone that this interface is a member of. (Optional)

Comments

Text describing the current object. (Optional)