Properties

Name

Specifies a symbolic name for the interface. (Identifier)

IP

The host name to store the assigned IP address in, if this network object exists and have a value other then 0.0.0.0 the PPTP/L2TP client will try to get that one from the PPTP/L2TP server as preferred IP. (Optional)

Network

The network from which traffic should be routed into the tunnel.

RemoteEndpoint

The IP address of the L2TP/PPTP server.

TunnelProtocol

Specifies if PPTP or L2TP should be used for this tunnel. (Default: PPTP)

OriginatorIPType

Specifies what IP address to use as source IP in e.g. NAT. (Default: LocalInterface)

OriginatorIP

Manually specified originator IP address to use as source IP in e.g. NAT.

DNS1

IP of the primary DNS server. (Optional)

DNS2

IP of the secondary DNS server. (Optional)

Username

Specifies the username to use for this PPTP/L2TP interface.

Password

The password to use for this PPTP/L2TP interface.

PPPAuthNoAuth

Allow no authentication for this tunnel. (Default: No)

PPPAuthPAP

Use PAP authentication protocol for this tunnel. User name and password are sent in plaintext. (Default: Yes)

PPPAuthCHAP

Use CHAP authentication protocol for this tunnel. (Default: Yes)

PPPAuthMSCHAP

Use MS-CHAP authentication protocol for this tunnel. (Default: Yes)

PPPAuthMSCHAPv2

Use MS-CHAP v2 authentication protocol for this tunnel. (Default: Yes)

MPPENone

Allow authentication without Microsoft Point-to-Point Encryption (MPPE). (Default: Yes)

MPPERC440

Use an RC4 40 bit MPPE session key with MS-CHAP or MS-CHAP v2 authentication protocol. (Default: Yes)

MPPERC456

Use an RC4 56 bit MPPE session key with MS-CHAP or MS-CHAP v2 authentication protocol. (Default: Yes)

MPPERC4128

Use an RC4 128 bit MPPE session key with MS-CHAP or MS-CHAP v2 authentication protocol. (Default: Yes)

DialOnDemand

Enable Dial-on-demand which means that the L2TP/PPTP tunnel will not be setup until traffic is sent on the interface. (Default: No)

ActivitySensing

Specifies if the dial-on-demand should trigger on inbound or outbound traffic or both. (Default: BiDirectional)

IdleTimeout

Idle timeout in seconds for dial-on-demand. (Default: 3600)

Metric

Specifies the metric for the auto-created route. (Default: 90)

MTU

Specifies the size (in bytes) of the largest packet that can be passed onward. (Default: 1456)

AutoInterfaceNetworkRoute

Automatically add a route for this interface using the given remote network. (Default: Yes)

MPPEAllowStateful

Allow usage of Stateful MPPE (less secure, use only for compatibility). (Default: No)

IPsecInterface

Use this IPsec interface to encypt the traffic to the L2TP server. (L2TP/IPsec). (Optional)

SNMPIndex

Interface index assigned by the system when persistent interface indexes are enabled. (Default: 0)

Attribute

Special Attribute of the current object. (Optional)

MemberOfRoutingTable

All or Specific. (Default: All)

RoutingTable

Specifies the PBR table to insert the interface IP route into. It also means that the specified routing table will be used for all routing lookups, unless overridden by a PBR rule. (Default: main)

Zone

(Optional) Specifies the Zone that this interface is a member of. (Optional)

Comments

Text describing the current object. (Optional)