3.126. RoutingSettings

Description

Configure the routing capabilities of the system.

Properties

RouteFailOver_IfacePollInterval
Time (ms) between polling of interface failure. (Default: 500)
RouteFailOver_ARPPollInterval
Time (ms) between ARP-lookup of gateways. May be overridden for each route. (Default: 1000)
RouteFailOver_PingPollInterval
Time (ms) between PING'ing of gateways. (Default: 1000)
RouteFailOver_GraceTime
Time (s) between startup/reconfigure and monitoring start. (Default: 30)
RouteFailOver_ConsecFails
Number of consecutive failures before route is marked as unavailable. (Default: 5)
RouteFailOver_ConsecSuccess
Number of consecutive success before route is marked as available. (Default: 5)
Transp_CAMToL3CDestLearning
Do L3 Cache learning based on destination IPs and MACs in combination with CAM table contents. (Default: Yes)
Transp_DecrementTTL
Decrement TTL on packets forwarded between transparent interfaces. (Default: No)
Transp_CAMSize_Dynamic
Allocate the CAM Size value dynamically. (Default: Yes)
Transp_CAMSize
Maximum number of entries in each CAM table. (Default: 8192)
Transp_L3CSize_Dynamic
Allocate the L3 Cache Size value dynamically. (Default: Yes)
Transp_L3CSize
Maximum number of entries in each Layer 3 Cache. (Default: 8192)
Transp_RelaySTP
Relay Spanning-Tree (STP, RSTP and MSTP) Bridge Protocol Data Units to all switch interfaces. (Default: Drop)
Transp_RelayMPLS
Forward MPLS packets to all switch interfaces. (Default: Drop)
RFO_GratuitousARPOnFail
Send gratuitous ARP on failover to alert hosts about changed interface ethernet and IP addresses. (Default: Yes)
RFO_GratuitousProxyARPOnFail
Send gratuitous ARP packets on failover to alert hosts about changed interface ethernet address of Proxy ARPed hosts in ARP cache. (Default: No)
Transparency_ATSExpire
Lifetime of an unanswered ATS entry in seconds. (Default: 3)
Transparency_ATSSize
Number of ATS entries, total. (Default: 4096)
NullEnetSender
Action to take if sender MAC in the ethernet header is the null address (0000:0000:0000). (Default: DropLog)
BroadcastEnetSender
Action to take if sender MAC in the ethernet header is the broadcast ethernet address (FFFF:FFFF:FFFF). (Default: DropLog)
MulticastEnetSender
Action to take if sender MAC in the ethernet header is a multicast ethernet address. (Default: DropLog)
[Note] Note
This object type does not have an identifier and is identified by the name of the type only. There can only be one instance of this type.