Properties

Name

Specifies a symbolic name for the interface. (Identifier)

Members

A set of Ethernet interfaces to aggregate. (Optional)

DistributionAlgorithm

Specifies how outbound traffic will be distributed among the active links. (Default: Combination)

Mode

Specifies the method used to aggregate links. (Default: Static)

LACPActivity

Specifies if the system should actively attempt to initiate LACP negotiations or wait for a partner system to do so. (Default: Active)

LACPTimeout

Specifies how soon the system will reselect active links if a link is broken. (Default: Long)

LACPSystemPriority

System priority value to be sent in LACP messages. (Default: 1)

MACAddress

The hardware address for the interface. (Optional)

IP

The IP address of the interface.

Network

The network of the interface.

DefaultGateway

The default gateway of the interface. (Optional)

Broadcast

The broadcast address of the connected network. (Optional)

EnableIPv6

Enable processing of IPv6 traffic on this interface. (Default: No)

IPv6IP

The IP address of the interface.

IPv6Network

The network of the interface.

IPv6DefaultGateway

The default gateway of the interface. (Optional)

RouterDiscovery

Uses Router information (ND RA) from local network to auto-configure Network and Default Gateway addresses. (Default: No)

AutoIPv6IP

Automatically configures IP Address using Network Address and EUI-64. (Default: No)

DHCPv6Enabled

Enable DHCPv6 client on this interface. (Default: No)

PrivateIP

The private IP address of this high availability node. (Optional)

PrivateIP6

The private IP6 address of this high availability node. (Default: localhost6)

NOCHB

This will disable sending Cluster Heartbeats from this interface (used by HA to detect if a node is online and working). (Optional)

MTU

Specifies the size (in bytes) of the largest packet that can be passed onward. Must be 1294 or larger when IPv6 is enabled. (Default: 1500)

Metric

Specifies the metric for the auto-created route. (Default: 100)

DHCPEnabled

Enable DHCP client on this interface. (Default: No)

DHCPHostName

Optional DHCP Host Name. Leave blank to use default name. (Optional)

DHCPVendorClassId

Optional DHCP Vendor Class Identifier. Leave blank to use default name. (Optional)

AutoSwitchRoute

Allows traffic to be forwarded transparently across all interfaces with Transparent Mode enabled that belong to the same routing table. (Default: No)

DHCPPassthrough

Allow DHCP to pass through transparently. (Default: No)

NonIPPassthrough

Allow non-IP protocols to pass through transparently. (Default: No)

BroadcastFwd

By default, broadcast traffic is dropped. Enabling this setting will allow directed broadcast (eg. 192.168.0.255) but general broadcast (255.255.255.255) will still be dropped. (Default: No)

HostLearning

Enable host learning by flooding incoming packet instead of sending ARP packets. All Transparent mode interfaces in a routing table must have the same Host Learning setting. (Default: No)

AutoInterfaceNetworkRoute

Automatically add a route for this interface using the given network. (Default: Yes)

AutoDefaultGatewayRoute

Automatically add a default route for this interface using the given default gateway. (Default: Yes)

DHCPDNS1

IP of the primary DNS server. (Optional)

DHCPDNS2

IP of the secondary DNS server. (Optional)

DHCPv6DNS1

IP of the primary IPv6 DNS server. (Optional)

DHCPv6DNS2

IP of the secondary IPv6 DNS server. (Optional)

DHCPPreferedIP

Set a preferred IP address which will be included in the request to the DHCP server. (Optional)

DHCPAllowStaticRoutes

Allow the use of static routes sent from the DHCP server. (Default: No)

DHCPPreferedLeaseTime

The preferred lease time, specified in minutes, that will be suggested to the DHCP server. (Optional)

DHCPLeaseFilter

Allowed IP address range(s) for the DHCP lease. (Optional)

DHCPServerFilter

IP address range(s) for the DHCP servers from which leases are accepted. (Optional)

DHCPDisallowIPConflicts

Do not allow IP collisions with static routes. (Default: Yes)

DHCPDisallowNetConflicts

Do not allow network collisions with static routes. (Default: Yes)

DHCPv6PreferredIP

Set a preferred IPv6 address which will be included in the request to the DHCPv6 server. (Optional)

DHCPv6ValidLifeTime

The length of time in seconds that an address remains valid for sending and receiving packets. When expired, the host is not allowed to use the provided address any more and should acquire a new one. (Optional)

DHCPv6PreferredLifeTime

The preferred lease time, specified in minutes, that will be suggested to the DHCP server. (Optional)

DHCPv6LeaseFilter

Allowed IP address range(s) for the DHCPv6 lease. (Optional)

DHCPv6ServerFilter

IP address range(s) for the DHCPv6 servers from which leases are accepted. (Optional)

DHCPv6DisallowIPConflicts

Do not allow IP collisions with static routes. (Default: Yes)

EnableRouterAdvertisement

Enable Router Advertisement for this interface. (Default: No)

SNMPIndex

Interface index assigned by the system when persistent interface indexes are enabled. (Default: 0)

Attribute

Special Attribute of the current object. (Optional)

MemberOfRoutingTable

All or Specific. (Default: All)

RoutingTable

Specifies the PBR table to insert the interface IP route into. It also means that the specified routing table will be used for all routing lookups, unless overridden by a PBR rule. (Default: main)

Zone

(Optional) Specifies the Zone that this interface is a member of. (Optional)

Comments

Text describing the current object. (Optional)