Properties

Enabled

Enable High Availability. (Default: No)

Sync

Specifies if cluster members are to synchronize configuration data. (Default: Yes)

ClusterID

A (locally) unique cluster ID to use in identifying this group of HA firewalls. (Default: 0)

SyncIface

Specifies the interface used for state synchronization.

NodeID

Master or Slave. (Default: Master)

HASyncBufSize

How much sync data, in KB, to buffer while waiting for acknowledgments from the cluster peer. (Default: 4096)

HASyncMaxPktBurst

The maximum number of state sync packets to send in a burst. (Default: 100)

HAInitialSilence

The number of seconds to stay silent on startup or after reconfiguration. (Default: 5)

UseUniqueSharedMac

Use a unique shared mac address for each interface. (Default: Yes)

HADeactivateBeforeReconf

Deactivate(hand over) before Reconfiguration if Active. (Default: Yes)

ReconfFailoverTime

Number of non-responsive seconds before failover at HA reconf (0=immediate failover). (Default: 0)

HAFailoverTime

Number of milliseconds before failover when active HA node becomes non-responsive. (Default: 750)

HASyncProtocol

Ethernet protocol number to use for state sync packets. (Default: 0xc157)

HAFastInactive

Go inactive directly without waiting for HA peer to go active. (Default: No)

HAFastInactiveActiveDelay

Delay in milliseconds before HA peer goes active after receiving sync message that other side went fast inactive. (Default: 200)

HAFastInactiveMaxInactiveTime

Maximum time in seconds for both sides inactive after going fast inactive. (Default: 2)