Properties

Name

Specifies a symbolic name for the relayer. (Identifier)

SourceInterface

Specifies the name of the receive interface for RADIUS relay requests.

ClientIPFilter

Specifies the network that the AP belongs to.

ListeningIP

Specifies the local IP address on which the system receives Access Point requests. This parameter is optional and will use IP of source interface, if not set. (Optional)

ListeningPort

Specifies the listening port on which the system receives Access Point requests. (Default: 1812)

RemoteServerIP

Specifies the IP address of the remote RADIUS server.

RemoteServerPort

Specifies the port of the remote RADIUS server. (Default: 1812)

SendingIP

Specifies the local IP address from which the system sends requests to the remote Remote RADIUS server. This parameter is optional and will use IP of routed destination interface, if not set. (Optional)

IdleTimeout

A successfully authenticated user will be logged out automatically after this many seconds, if no traffic has been received from the user's IP address. (Default: 1800)

SessionTimeout

A successfully authenticated user will be logged out automatically after this many seconds, even if traffic has been received from the user's IP address. (Default: 0)

UseServerTimeouts

Use timeouts received from the authentication server. If no values are received, the manually specified values will be used. (Default: No)

DHCPServer

Specifies the DHCP server rule that is responsible for distributing leases for authenticated users.

OverrideUserDataInterface

Optionally specify the source interface for the authenticated user data. If not specified, the configured RADIUS Relay source interface will be used. (Optional)

Attribute

Special Attribute of the current object. (Optional)

LogEnabled

Enable logging. (Default: Yes)

LogSeverity

Specifies with what severity log events will be sent to the specified log receivers. (Default: Default)

RoutingTable

Specifies the routing table the clients host route should be added to. (Default: main)

Comments

Text describing the current object. (Optional)